Fits all standard steering cables including Morse, Teleflex, Detmar, etc.

Should be installed on all cable and side-mounted hydraulic steering systems to lubricate, clean and seal the system. Will more than double the life of a new cable system. Made of stainless steel. Installs in 10 minutes. Eliminates greasy steering rods forever.

Available in 2 sizes:

7/8" fits Johnson/Evinrude, most Mercury/Mariners, Chrysler/Force sterndrives and all Japanese motors.

1" fits Mercury/Mercruiser I/O's as well as many other I/O's.

Davis Instruments Cable Buddy™ is a complete steering cable lubricant system.Cable Buddy lubricates and virtually eliminates all wear in the inner cable, where most problems occur.
Seals moisture out, puts lubricant in
Prevents corrosion and freezing to 40°F ( 40°C)
Works on inboard, outboards, and inboard/outboard steering cables
Fits all major US and foreign motors (7/8" x 14 pitch threads)
Easy to install

Available for purchase is the complete kit (with 1 nut or 2), also the lubricant only and the nut/seal/fitting set only.

Seals off water intake and protects cables, wiring and gas lines. Made of durable vinyl plastisol. Split design allows placement without disconnecting cables. Available in 2 sizes: 3" opening, 4" opening.

A unique wiper seal that slips over the cable output ram and snaps onto the tilt tube nut. Dirt and corrosion are wiped out while essential lubrcation is sealed in the engine tilt tube. Adds years of service to a steering cable.

T-H FLEX is a lightweight jacketing for bundling and protecting wires, cables and hoses. Braided from high temperature yarns, T-H FLEX? offers total protection for wire and cable assemblies. The unique expansion characteristics makes T-H FLEX easy to slip on. Expands up to 4 times it's normal diameter.

These components provide an excellent system to protect cables and wiring from dirt, abrasion, sun and water. The molded polypropylene flange is internally threaded to retain hose and to make rigging adjustment simple. The back side of the flange is textured to allow inverted mounting. The hose is durable, flexible, and kink resistant. The molded vinyl cap provides a closure for the engine end of hose if needed. Kit contains 4' of 2" tubing and one flush mount flange.